Geckodrive Set 4x Driver G203V + 4x Schrittmotor 2.2Nm 57mm

Item number: 4-2-1-005

The G203V is one of Geckodrive's toughest drives and was designed with the intention of creating an indestructible stepper controller. It has short circuit protection on the motor outputs, reversed power supply polarity protection, over-voltage and under-voltage protection and is internally fused. Where most other drives would be damaged or potentially destroyed the G203V will survive. Because of its CPLD architecture we can offer three different versions of the drive, all with the same level of protection.

Exim Motor Step motor

     - 2,2Nm
     - 4 Amp
     - 57 mm
     - 2 Phase Hybrid
     - 110mm Long
     - 1,8

Inhalt:

4x Schrittmotordriver Geckodrive G203V
4x Schrittmotor Exim 2,2Nm

Category: Schrittmotor Sets

755,67 €

including 16% VAT., plus shipping

From	Price per unit
10	725,44 €
25	710,33 €
50	680,10 €

Not available now!

Delivery status: In Stock

Description

PHYSICAL AND ELECTRICAL RATINGS

	Minimum	Maximum	Units
Supply Voltage	18	80	VDC
Motor Current	0	7	A
Power Dissipation	1	13	W
Temperature	0	70	°C
Humidity	0	95	%
Motor Inductance	1	50	mH
Input Frequency	0	250	kHz
Step Pulse ?0? Time	2		uS
Step Pulse ?1? Time	1		uS
Direction Setup (Before step rising edge)	200		nS
Direction Setup (Hold after pulse rising edge)	200		nS
Signal Voltage	3.3	5	VDC
Weight	3.6		oz

The G203V is available in a G203V-Vacuum version as well. This changes the auto current standby to 0% as opposed to 70%, allowing it to operate in a high vacuum environment with minimal heating problems.

The G203V is also available in a G203V-CW/CCW version. This means that rather than taking a step and direction input it takes a CW and CCW input on the step and direction terminals. This is only necessary if your machine outputs CW/CCW signals as opposed to step and direction.

If you would like either of these options, please specify in the comments section of your order. Unless noted, all G203Vs will be shipped with the standard firmware.